From: Randy Dunlap Use 'legacy_mode' to check for SATA vs. PATA mode. Signed-off-by: Randy Dunlap --- drivers/scsi/libata-acpi.c | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-) --- linux-2616-rc4-ata.orig/drivers/scsi/libata-acpi.c +++ linux-2616-rc4-ata/drivers/scsi/libata-acpi.c @@ -437,7 +437,7 @@ int do_drive_get_GTF(struct ata_port *ap /* Don't continue if device has no _ADR method. * _GTF is intended for known motherboard devices. */ - if (ata_id_is_ata(atadev->id)) { + if (ap->legacy_mode) { err = pata_get_dev_handle(dev, &dev_handle, &pcidevfn); if (err < 0) { if (ata_msg_probe(ap)) @@ -459,7 +459,7 @@ int do_drive_get_GTF(struct ata_port *ap /* Get this drive's _ADR info. if not already known. */ if (!atadev->obj_handle) { - if (ata_id_is_ata(atadev->id)) { + if (ap->legacy_mode) { /* get child objects of dev_handle == channel objects, * + _their_ children == drive objects */ /* channel is ap->hard_port_no */ @@ -655,7 +655,7 @@ int do_drive_set_taskfiles(struct ata_po if (noacpi) return 0; - if (!ata_id_is_sata(atadev->id)) { + if (ap->legacy_mode) { printk(KERN_DEBUG "%s: skipping non-SATA drive\n", __FUNCTION__); return 0;